strait one piece tie rod length? (eye to eye)
 

Just wondering if anyone can tell me the exact "eye-to-eye" length for a strait one piece tie rod for the XR-10?
I really want to make one up at work tomarrow.... but i dont have my XR built yet to be able to get a eye to eye measurement.
If anyone can get this measurement for me it would be GREATLY appreciated8)"thumbsup"
Thanks so much!
I am running VANQUISH steering knuckles...

Do you have stock or VP knuckles?

I'm making a delrin one piece with threaded rod through it and the delrin is 130mm then the threaded rod will stick out each end and the revo ends will thread on the ends and bring you right at knuckle to knuckle."thumbsup" Dont remember the measurment,or I'm just not going to tell you becaause I have to test these tie rods before I start selling them to my friends. Then I'll get a vendor star and sell them here.

Vanquish knuckles...

Already for sale. These look really stout and have a low profile."thumbsup"

http://www.rccrawler.com/forum/axles-trannys-t-case/280830-%2A%2Aaxial-xr10-solid-steering-tierod%2A%2A.html

That's fine and I don't want to be an a**.
But I really think he is asking the length,
so he could custom make it himself.
That's way more fun than buying something you can do it oyurself.;-)
Would give you the numbers, but I have never had contacts with XR-10.

I have seen them forsale.... but why would i buy one when i am a fabricator by trade and make my own stuff. I get more satisfaction out of building a rig than i do running it... running it is just an added bonus for me.
Thats fine, no hard feelings if nobody wants to give me a measurement, i'll just wait until I get the rig assembled then i will figure it my self.
Im not trying to take away from anyones bussiness.... i NEVER make any products to sell on here and never will.
Just trying to save myself some time, thats all.

PS: If anyone does want to share the measurement with me... you could PM it to me... i wont tell anyone:ror:

there was a thread in here somewhere with tons od dimensions handed out ..... just try searching for it

If I remember this thread after this not so great day of work I am having I will take a picture of mine tonight with a tape measure for you. "thumbsup"

180mm

Thanks.... i guess i must have looked right over that.... somehow missed it.
I dont have the time to sit here and read that i used to.... im in the field welding 80 hours a week right now.... and when i do get a change to do some research im usually too tired to comprehend:flipoff::ror:

Its all good. I was just being sarcastic cause I knew someone was lurking (Ol Gravy) and would throw up 180mm within seconds! ;-)