need Axial Scorpion /AX10 front axle shafts
 

Is anyone still making some thing that will fit this old axle?

Will any of the current axle's shafts cross over?

I had wider CVD front shafts, but snapped one and had to go back to the OEM Dogbones

Re: need Axial Scorpion /AX10 front axle shafts
 

you can use og scx10 shafts but there week by todays standerds
a good upgrade would be to use wraith knuckles and chubs they call that the xr mod or the narrow xr mod
the narrow mod is basicly just modifying the stock housing and cut down shafts
the full xrmod requires a aftermarket spline kit
etherway its the best steering mod you can do without changing axles

Re: need Axial Scorpion /AX10 front axle shafts
 

Thanks for the info. I haven't heard of this before.

Is there a known thread on this mod?

Re: need Axial Scorpion /AX10 front axle shafts
 

do a search for the xr mod its vary comin mod boom racing sells the xrmod shafts so you dont need 2 sets of wraith universals althoughif going the narrow xr mod you will still need to cut the shafts down about a 1/4 of a inch i think beef tubes sells the splined part if going full xr width
boomracing has a really good explination of what a xr mod is and they sell the parts although you just want there shafts the rest can be bought on the cheap

https://www.boomracingrc.com/boom-ra...ont-rear--3011

Re: need Axial Scorpion /AX10 front axle shafts
 

heres a good thread http://www.rccrawler.com/forum/axial...row-xrmod.html

Re: need Axial Scorpion /AX10 front axle shafts
 

I did two versions of the XR mod in my AXR10 thread.

http://www.rccrawler.com/forum/axial...-sudu1-fl.html

Recently did another one using the SCX10 beeftubes wide, stock plastic XR10 hubs, knuckles and universals.

https://www.beeftubes.com/store/p50/...-_BRASS.html#/

Real easy and lots of benifits.