Yeti 1/10 rear driveshaft?

[Gixxer1237]

So the screw that runs through the shaft into the diff stripped out. Is there another shaft that will fit from another bone axial kit? My shop says they cant get a shaft for it and I cant gund anything under $40 for it in stock. Anyone want to sell a stock rear driveshaft and couplers?

[magic_yeti]

Never had a issue on my driveshaft except loosing middle splines. Broke my dif-input, but nothing on my driveshaft . If you mean stripped screw is it only a problem with the cap? The plastic caps can be replaced by alloy caps.
Alloy caps https://www.amainhobbies.com/st-raci...1114gm/p418004

Or depends what you need amain has it in stock:

Plastic parts https://www.amainhobbies.com/axial-w...i31114/p363513
Driveshaft Coupler https://www.amainhobbies.com/axial-w...i31148/p363532
Screws : https://www.amainhobbies.com/axial-4...ia0286/p220694

or aftermarket Driveshafts
SSD: https://www.amainhobbies.com/ssd-rc-...d00073/p498756
MIP: https://www.amainhobbies.com/mip-axi...p18170/p775240
Hot Racing: https://www.amainhobbies.com/hot-rac...syet37/p649953

or a complete set: https://jennysrc.com/collections/1-1...114-axi90026-1

[Gixxer1237]

Thanks. I think I'll just through a SSD in it and get read of the twizzler shaft anyway.

[Gixxer1237]

Decided to just order the MIP and be done with it. SSD had a few ti many reports of failure. And I have a rule, anything that breaks gets upgraded. Just dont drive this much and was going to cheap out but smartened up.