Castle 3800kv 1410 or 2400kv 1415
 

So my yeti comes tomorrow and I plan on selling the brushless out of it right away and put something a little more potent in it. I have a castle 2400kv funny car motor and MMP and a 5mm shaft 3800KV motor. I have both 2s and 3s lipos. Looking for opinions on which way to go with the yeti.

Re: Castle 3800kv 1410 or 2400kv 1415
 

I can only speak from personal experience..but I just tuned the factory esc with castle link and this thing flips on its roof on take off!!!. Helps a ton...But if you change go sensor'd system much smoother and same power. Hope this helps .

On 3s

Re: Castle 3800kv 1410 or 2400kv 1415
 

I went with a Pro4HD 3500kv on 3s and it feels pretty good. I would go sensored if switching to the MMP, if not I think the 3800 sounds good.

Re: Castle 3800kv 1410 or 2400kv 1415
 

Can the stock esc run the 3800 on 3s? I have a castle fan for it but not sure if heat is an issue in the yeti's

Re: Castle 3800kv 1410 or 2400kv 1415
 

I was wondering the same thing on the 2400kv motor I know its not sensored but wouldn't the torque of the lower kv help for crawling. I know the yeti and slash aren't the same but it's the go to setup for the slash bashers they can gear it to the moon and not have heat issues on 3s.