| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
09-10-2015, 11:00 PM
| #1 |
| Rock Stacker Join Date: Jun 2015 Location: Azusa
Posts: 53
|  tekin pro4 1860 in yeti with stock esc?
I might have a chance to get a tekin pro4 1860kv motor but idk if it would fit or work well. will it fit and could I use the stock axial vanguard esc? thx
|
|  |
| Sponsored Links | |
| | |
|
09-10-2015, 11:05 PM
| #2 |
| RCC Addict Join Date: Aug 2012 Location: Philippines
Posts: 1,652
| Re: tekin pro4 1860 in yeti with stock esc?
You could just fine. It would be pretty slow though
|
|
| |
|
09-10-2015, 11:54 PM
| #3 |
| Rock Stacker Join Date: Jun 2015 Location: Azusa
Posts: 53
| Re: tekin pro4 1860 in yeti with stock esc?
even with 3s? I want to have at least the same speed as the stock motor
|
|
| |
|
09-11-2015, 12:10 AM
| #4 | |
| RCC Addict Join Date: Aug 2012 Location: Philippines
Posts: 1,652
|
It would be almost half as fast as my 3000KV Pro4 HD on 3S in theory. If you could also get an ESC that could handle 4S, and have 4S a battery then it might be pretty good. But then you'd be over the cost of just getting a higher KV motor to begin with. Granted, a higher voltage / lower KV setup would likely run cooler. Quote:
1860KV is only 57% as fast as 3150 on any voltage. Last edited by THX_138; 07-27-2016 at 08:15 AM. | |
|
| |
|
09-11-2015, 06:12 AM
| #5 |
| I wanna be Dave Join Date: Jan 2005 Location: Raleigh-ish vicinity
Posts: 3,846
| Re: tekin pro4 1860 in yeti with stock esc?
The 1850kv motor on 4S performs similarly to the stock motor on 2S except with cooler temps. If you are going to be running 3S, then something around 3300-3500kv is what you want.
|
|
| |
|
tekin pro4 1860 in yeti with stock esc? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tekin pro4 4600kv in yeti? | jordanbottle | Axial Yeti | 7 | 05-20-2015 04:46 PM |
| |
Linear Mode
