What hubs for Axial 12mm hex 2.2s beadlocks?
 

OK, I didn't get an answer on this so I'm asking again. For the Yeti kit, I want to use 12mm hex Axial 2.2 beadlocks but I do not know what hubs I need. I've seen pics of guys using them but what hubs are they using to get the standard width of the wheels? Direct bolt on would narrow the width too much.

Re: What hubs for Axial 12mm hex 2.2s beadlocks?
 

These kind work Great! Just a shameless plug here, but VP hubs? Guess which size I want to run? 4-40 screw's?...

I go with Shift hubs from Lattice Innovations!
Adjustable offset, 6 holes tapped 4-40(or use to be) and 6 holes drilled out to 2.5mm, ready for a 3mm tap!

They are from BC-Brian...
Same price as a set of VP hubs, adjustable from .225-.850. Tap for 3mm and run ur favorite color screw's...
Speaking of color, you can get them ano'd whatever color you want!!! (For a fee)..

http://tapatalk.imageshack.com/v2/15...442e297f2d.jpg

Even come in slims!

http://tapatalk.imageshack.com/v2/15...a692882c1a.jpg

Comparison

http://tapatalk.imageshack.com/v2/15...79f2085aac.jpg

You can get rid of the PITA hex's too! These are made for a right tolerance that Snuggly fits the pin.
I have found to make for less slop and less broken/bent pins!

Re: What hubs for Axial 12mm hex 2.2s beadlocks?
 

Not what I was asking about, sorry.

What I am asking is, I want to mount the regular old 12mm hex Axial 2.2 beadlock wheels onto the Yeti. The Yeti kit already has 12mm hexes however I need wideners or hubs that will give me the factory width.

Re: What hubs for Axial 12mm hex 2.2s beadlocks?
 

As far as I know, the only way to counter that offset in the rear would be wheels with a different offset from the front to even it out.

Re: What hubs for Axial 12mm hex 2.2s beadlocks?
 

You could use these widener

2.2" Wheel widner (4) (Offset: +13mm) [J51032] : JunFac.com

I didn't try, some say it won't hold off on a 3s yeti.

You could be the tester of these!!!

Re: What hubs for Axial 12mm hex 2.2s beadlocks?
 

i've tried hot racing hex widener that look like the junfac and they hold up with 2.8 proline paddle for the two 3s packs ive put through them but like the junfac more the hot racing as the pin trough the widener and hold in place with a oring