RCCrawler Forums

Mattwarner · 01-13-2016, 07:23 AM

I am just building the Kit version and have assembled the transfer box, when connecting the rear driveshaft onto the transfer box tightening the grub screw causes the drive (cup?) to bind badly on the gearbox to the point I can hardly turn it by hand?

Anyone else have this issue? I took the gearbox apart and checked its been assembled with the gear shaft round the right way and looks fine, didn't want to have to trim the driveshaft cup if someone else had any options?

RCO · 01-13-2016, 07:26 AM

Yes, i had this issue as well. I put some shims on... think it was 0.6mm

01-13-2016, 07:23 AM	#1
Mattwarner Newbie Join Date: Dec 2015 Location: UK Posts: 20	Yeti Kit rear driveshaft binding? I am just building the Kit version and have assembled the transfer box, when connecting the rear driveshaft onto the transfer box tightening the grub screw causes the drive (cup?) to bind badly on the gearbox to the point I can hardly turn it by hand? Anyone else have this issue? I took the gearbox apart and checked its been assembled with the gear shaft round the right way and looks fine, didn't want to have to trim the driveshaft cup if someone else had any options?

01-13-2016, 07:26 AM	#2
RCO Pebble Pounder Join Date: Nov 2015 Location: Switzerland Posts: 148	Re: Yeti Kit rear driveshaft binding? Yes, i had this issue as well. I put some shims on... think it was 0.6mm

Yeti Kit rear driveshaft binding? - Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Yeti Kit Rear Driveshaft Issue	stone202	Axial Yeti	8	11-13-2015 10:18 AM
Yeti kit rear dif. mesh	KellyC	Axial Yeti	8	04-13-2015 05:00 PM

Sponsored Links

RCCrawler Forums

Thread: Yeti Kit rear driveshaft binding?