Mamba x mounting question I’m trying to install a new mamba x esc on my 1/10 yeti. What is everybody using to mount the esc. I bought the rpm esc cage and it doesn’t fit. Wondering if there’s another cage I don’t know about. I could just use double sided tape and a zip tie. |
Re: Mamba x mounting question https://uploads.tapatalk-cdn.com/201...c88cb86192.jpg I used servo tape on my MMX. Sent from my iPhone using Tapatalk |
Re: Mamba x mounting question I will just do that |
Re: Mamba x mounting question Yup.i used velcro to absorbe some of the shock the MM2 im using in my 2wd slash that only sees road use ,I have the suspension almost bottomed out to keep the chassis low .I think it helps the electronics somewhat safer .im not sure this helps , but anyhow thats how i have mine . Sent from my SM-G965U using Tapatalk |
Re: Mamba x mounting question Servo tape |
Re: Mamba x mounting question The RPM cage fits if you trim one corner https://i.postimg.cc/yY92J8cF/BA4-A2...96731-B925.jpg https://i.postimg.cc/ZYX1KdBb/BF5-D1...-E0-E2-BF6.jpg |
Re: Mamba x mounting question Just double tape, best is an outdoor tape like tesa powerbond outdoor https://www.tesa.com/en/consumer/tes...d-outdoor.html (don't know if you get it in the states but sure similar are available) and a zip tie to secure just in case. But normally not necessary, if i dismount my esc i have to be very gently to not destroy the esc case, just take care to remove the sticker on the bottom of the esc. the rpm cage is nice too but needs a little modification. |
Re: Mamba x mounting question Quote:
Do u know the part number for that cage cause I must of bought the wrong one. The two mounting holes do not line up. |
Re: Mamba x mounting question |
Re: Mamba x mounting question I use RC Helicopter double sided GYRO gel tape, it comes in several thicknesses and it does an amazing job of vibration dampening, I also use it on any RX with AVC or TSM (they have gyro's in them). I hope this helps, Ed |
Re: Mamba x mounting question I used the super strong Velcro on my YetiXL - it's held up so far. It's also tethered with a zip tie in case it comes loose. I can lift the entire truck by the ESC without the Velcro separating. https://www.homedepot.com/p/Scotch-1...6731/204465390 |
All times are GMT -6. The time now is 02:44 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com