Yeti 1/10 rear driveshaft?
 

So the screw that runs through the shaft into the diff stripped out. Is there another shaft that will fit from another bone axial kit? My shop says they cant get a shaft for it and I cant gund anything under $40 for it in stock. Anyone want to sell a stock rear driveshaft and couplers?

Re: Yeti 1/10 rear driveshaft?
 

Never had a issue on my driveshaft except loosing middle splines. Broke my dif-input, but nothing on my driveshaft :mrgreen:. If you mean stripped screw is it only a problem with the cap? The plastic caps can be replaced by alloy caps.
Alloy caps https://www.amainhobbies.com/st-raci...1114gm/p418004

Or depends what you need amain has it in stock:

Plastic parts https://www.amainhobbies.com/axial-w...i31114/p363513
Driveshaft Coupler https://www.amainhobbies.com/axial-w...i31148/p363532
Screws : https://www.amainhobbies.com/axial-4...ia0286/p220694

or aftermarket Driveshafts
SSD: https://www.amainhobbies.com/ssd-rc-...d00073/p498756
MIP: https://www.amainhobbies.com/mip-axi...p18170/p775240
Hot Racing: https://www.amainhobbies.com/hot-rac...syet37/p649953

or a complete set: https://jennysrc.com/collections/1-1...114-axi90026-1

Re: Yeti 1/10 rear driveshaft?
 

Thanks. I think I'll just through a SSD in it and get read of the twizzler shaft anyway.

Re: Yeti 1/10 rear driveshaft?
 

Decided to just order the MIP and be done with it. SSD had a few ti many reports of failure. And I have a rule, anything that breaks gets upgraded. Just dont drive this much and was going to cheap out but smartened up.