| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
12-03-2019, 10:10 AM
| #1 |
| Pebble Pounder  Join Date: Oct 2015 Location: Greensboro
Posts: 133
|  Yeti X conversion/ 4x4 slash???
I remember a long while back CBE fab had the yeti x conversion that used Traxxas slash parts. I tried to ask this on a Traxxas forum with no response. Does anyone know if regular 2.2 bead locks will clear the knuckles on a slash 4x4 in stock form? I was considering ordering a roller slash from eBay and building an IFS/IRS bouncer on a custom chassis but wasn’t sure if regular 2.2 wheels will clear. Any help would be appreciated Sent from my iPhone using Tapatalk |
|  |
| Sponsored Links | |
| | |
|
12-03-2019, 11:05 AM
| #2 |
| RCC Addict Join Date: Nov 2014 Location: Nowhere
Posts: 1,326
| Re: Yeti X conversion/ 4x4 slash???
Off the top of my head I don't think they clear unless you have a lot of negative offset, to the point where the hex is pretty close to the rear lip of the wheel. It's not a problem with the 3.0 inner SC wheels of course.
|
|
| |
|
Yeti X conversion/ 4x4 slash??? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Slash 4x4 Rally Conversion | matgyver | Rally | 49 | 10-01-2015 10:50 AM |
| Slash 4x4 to Yeti Conversion Possible? | deadbase | General Crawlers | 5 | 05-27-2015 02:43 PM |
| Slash 4x4 Rally Conversion | alexchen86 | Rally | 1 | 09-21-2012 04:19 PM |
| 4x4 Stampede to Slash Chassis Conversion | Greatscott | Non Crawler RC's | 0 | 06-19-2011 09:52 PM |
| |
Linear Mode
