Yellow Yeti

[JimInMiami]

I recently picked up an unbuilt Yeti kit in the classified section from one of the site's long-time members. This one came with a bunch of aftermarket parts including:

Proline Bug body
RPM front A-Arms
UC FAB rear lower control arms
Vanquish bulkhead/gearbox
Vanquish front skid plate
Vanquish front caster blocks
Vanquish front knuckles
Vanquish front shock tower
Vanquish front shock relocation bracket
Vanquish motor mount

Besides the goodies that came w/ the kit, I added a MIP rear drive shaft and replaced all the plastic pivot balls with metal ones.



The stock lower link reinforcement plates were repurposed for the upper links and almost look like they were meant for them.



Even at maximum pre-load the rear shock springs seam kind'a soft. I'll give them a try and have some firmer ones on hand case they don't work out.



I wanted something fun for the paint scheme, it's a Bug after all!



I also picked up a set of no-name eBay alloy beadlocks. Tires are stock for now.

[FlatLander72]

Looks good! I wish I could find one. I think I missed my chance.

One point to note. The pinion angle is off on the rear axle. It should point at the t-case just under where the drive shaft connects to it. See if there is some way to lengthen the upper arms. Did the kit come with metal or plastic uppers?

Sent from my Moto Z (2) using Tapatalk

[Steve g]

Originally Posted by FlatLander72

Looks good! I wish I could find one. I think I missed my chance.

One point to note. The pinion angle is off on the rear axle. It should point at the t-case just under where the drive shaft connects to it. See if there is some way to lengthen the upper arms. Did the kit come with metal or plastic uppers?

Sent from my Moto Z (2) using Tapatalk

Not to nitpick here, but the pinion should be parallel with the transmission output for the u joints to cancel out the oscillation of each other.

Sent from my SM-G970U using Tapatalk

[JimInMiami]

Originally Posted by Steve g

Not to nitpick here, but the pinion should be parallel with the transmission output for the u joints to cancel out the oscillation of each other.

Not a nitpick at all, rather thanks for the heads up both of y'all. I had noticed the pinion angle was funny looking but then forgot top go back and measure the eye-to-eye lower rod length. Turns out it was a couple of mm too long.

All good now after installing shorter rod ends.

[Jeanethics]

Looks great

[JimInMiami]

Originally Posted by Jeanethics

Looks great

Thanks, I'm looking fwd to test driving this weekend.

[Stormin2u]

Congrats, she's a good looking build! Your first serious test drive will put a smile on your face without question. Take it easy on the jumps until you have a good balance and perfect shock set up. Something I learned from experience, the Yeti is a fun to drive beast, its my first choice for bashing. ... Enjoy!!!