ill be out there about 1030 or so.. ill just drive in. ill see u then.

ok c ya thn

Was a fun day out at the lake today..... got some new shoes for the little Ford....

http://i294.photobucket.com/albums/m...nib/007-37.jpg

Then i thought I would go swimming in the mud pit on the way out....

http://i294.photobucket.com/albums/m...nib/009-38.jpg
http://i294.photobucket.com/albums/m...nib/008-44.jpg
http://i294.photobucket.com/albums/m...nib/010-35.jpg

Thanks guys for yanking my dumb ass out of the mud today:roll: I feel lucky to have met so many class acts in this hobby."thumbsup"

Whaaaaat :shock: My claws will be in tomorrow too :ror: I see your running them backwards. So how do they work compared to the boggers?? I'll take them off your hands if you like :ror:

All the cool kids run them backwards!! :wink: They seem to crawl really well, but the boggers really tore up the snow in Reno, so i'm mounting those on another set of wheels for backup.:mrgreen:

Attention all my Nor-Cal scaler buddies, here is the link to the G6 love of rock write up and results.

http://www.rccrawler.com/forum/showp...7&postcount=46


Thank you all again for braving the pass in inclement weather and it was nice to meet some cool ass new people!

today was a blast. had 6 scalers was fun guys...

Anyone heading out to the lake this weekend?

Here ya go guys;


http://www.rccrawler.com/forum/recon-g6/301535-r-e-c-o-n-g6-challenge-folsom-g6-blues-part-deux.html

I'm planning on it.

I was planning on it two, I should have my Honcho up and running by then.

Sweet Saturday 10:30AM @ Dotons Point???

Sounds good.

im down to join ya guys. hope the rain stays out the way. need to see how the boggers work!
http://i548.photobucket.com/albums/i...s/IMG_2272.jpg

swapping axles
 

hey guys im thinking of swapping my axels from my honcho scale truck with a losi comp rig axels with worm gear

what do you think

I was going to do that to a unimog build. My buddy said I might need a higher rpm motor to get regular speed out of it. I was thinking of using the trans also but the tranny would be an issue for heat at the continued speeds we are doing on trail runs and comps. Keep us posted "thumbsup"

Read through the LCC thread, guys have been tinkering with worm drives for quite a while. Personally I've seen nothing but smoked motors and esc's, and they never could get any speed or even decent runtime out of them. Personally I think it's just a bad idea. Just my 2 cents.:mrgreen:

Rainy day today, got alot done on the G-6 crusher:mrgreen:.

Lookin good, Bill ! "thumbsup"

G6 crusher :shock: Does that mean Big Bill is making a trek to one of the G6's :ror: