http://i208.photobucket.com/albums/b...psbzeehlzc.png

Losi Crawler Front and Rear Axle plates.

Front plate allows you to offset your steering servo and battery on the front axle. Maximizing front axle weight and allowing for symmetrical triangulation to the upper links.

It comes with an extra bolt on plate that rides above the front input shaft. You can mount your esc and/or rx on the plate if you choose.

All top side holes are countersunk to use the stock 4-40 thread hardware - you will need countersunk hardware to mount to the axle and vertical style servo mounts.

NOTE: Front plate has been designed around the common XR conversion for Losi axles.
It measures at 5'' across and may not fit on stock axles and allow for max steering.

Rear axle plate allows you to fine tune your rear upper links at the axle. Raising or lowering them with symmetrical triangulation.

Axle mounting holes are machined for 4-40 stock hardware while link holes are for more typical 3mm. This allows you to use common ball ends and stock axle hardware.

Both cut from 2mm 3k Twill weave Carbon Fiber.

Front axle plate - $18.00
Rear axle plate - $12.00
Custom engraving available for front plate - 5$

International shipping is available "thumbsup"

Available through Catalog

http://i208.photobucket.com/albums/b...psneh2kjfi.jpg

http://i208.photobucket.com/albums/b...psf5hnc5cw.jpg

Thanks for looking - Any questions feel free to ask. "thumbsup"

Originally Posted by snapon boy (Post 5580242) Very nice product! Sent from my SAMSUNG-SM-N900A using Tapatalk