a few hours of boardom + foam = my creation! (flyers)

[STANG KILLA SS]

started this at about 10 last night, finished up at noon

36" 3D foamie bipe.

fuse is 2 pieces of pink house insulation foam epoxied together
the rest is hobby lobby project board foam.
shes a pig... :-(
i just got to make the motor mount, gear, control horns, and probly lay some graphics on her, then swap all the electronics and brushless gear out of my airfoilz 540.







me and that pink foam didnt get along, as you can tell by the rips and holes in the edges. the kitchen is covered in white and pink "snow" lol

[RedNeck Rc]

The fun of foam building, you going to go brushless right? I need to make a new 3D but I am stuck playing with my Aero-Aces. Cant wait to knife edge my new plane in my drawings. My goal is to make it fly better in knife edge than in regular high alpha.


**edit**
-just skipped over the bit about the brushless gear from your old plane.