SSD Third Member for Baja/Rock Rey Review First I'll start with how I got one. I was doing my usual posting around the board and got a message from SSD asking if I would like to try one of their third members? Only catch was I had to do a review. So here it is. My review on the SSD third member. First the packaging, Everything was individually wrapped to keep it from scratching. A+ for packaging https://uploads.tapatalk-cdn.com/201...088b9afc1e.jpg Then there is bearing size. Much larger on both sides. Very nice as the stockers are way too small. These should hold up well to all kinds of running. A for bearing size. https://uploads.tapatalk-cdn.com/201...96e4fb88e0.jpg Up next, the install. His took a whole 5 minutes. The only issues was breaking the overload of loctite on the drive shaft to slide it off. After it was installed I seem to have a tighter mesh. Not sure if this was planned but it's definitely not too tight. It feels as it would if I went it to shim it only I didn't use any shims. A+ for ease of install. https://uploads.tapatalk-cdn.com/201...afb8057eff.jpg https://uploads.tapatalk-cdn.com/201...3639fe5f84.jpg https://uploads.tapatalk-cdn.com/201...08c7bba169.jpg https://uploads.tapatalk-cdn.com/201...7ac064f779.jpg So that's it for the install. One of the easiest things I have ever done. I have only run one pack through it so far but it feels great and I haven't had any issues. I will be back to update after a few more runs but so far so good. |
Re: SSD Third Member for Baja/Rock Rey Review I have to agree about install.... mine was the smoothest install on my yeti. Wish I had done the wide, but I won't complain, great product! Hang up and Drive |
Re: SSD Third Member for Baja/Rock Rey Review I can also add my SSD install was super easy. Inner bearing was a little tight but got it in no problem. Getting the stock driveshaft grub screw out on the other hand was a pain. Had to use a mini torch to break the seal, since the whole grub screw has loctite on it. I did add one 0.1mm shim on the pinion ontop of the 0.1mm shim that came factory and mesh is perfect now. Good job SSD! "thumbsup" |
Re: SSD Third Member for Baja/Rock Rey Review Love my SSD third. Put about 7 pack through it. Now I can stop worrying about my bearing on 3s. Sent from my SM-G920V using Tapatalk |
All times are GMT -6. The time now is 03:31 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com