RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Electronics (http://www.rccrawler.com/forum/electronics/)
-   -   battery dies fast (http://www.rccrawler.com/forum/electronics/125334-battery-dies-fast.html)

iceman320 06-28-2008 06:24 PM

battery dies fast
 
so I got my crawler done I have a tq3 radio system and 4 wheel steer, and have noticed that the battery runs down pretty fast. Do I need to get a cc bec to connect to one of my servos? or will I have to run to tq3 receiver on a seprate battery? thanks.

Mriswith 06-28-2008 07:10 PM

What type and capacity of battery?

Cake Eater 06-28-2008 07:18 PM

What kind of motor and servo information could help too...

FYI, when asking a question, the more info you give the better the answers.


iceman320 06-28-2008 07:44 PM

I have a 8 cell 1500mah split pack from tcs and the motor is a 65 turn integy, and I have two hitec 645 mg servos for the 4ws.?

Mav-1981 06-28-2008 10:17 PM

I am not going to lie, i think the pack is part of the problem,lol. I have been trying out those same cells, and not very happy with my run times just on a servo and motor. Your motor and 2 of the servos shouldnt create a big issue being I can run a 55T and a single 645 on a 1320 2 cell lipo for better part of an hour.

iceman320 06-29-2008 09:19 AM

ok but does anybody have a split pack that's like 3000 mah? or is there some instructions somewhere that would show me how to build my own battery pack? cause I can't afford to switch to a lipo pack and charger right now.

mysharona 06-29-2008 10:47 AM

how fast is pretty fast? how much does the rig weigh? how's your gearing?

iceman320 06-29-2008 10:59 AM

i'm not sure how much my rig weighs. or how fast the battery dies I will have to time it when I go crawling next. but my gearing is a 21t pinion gear and a 87t spur gear. should I change my gearing?

Harvo 06-29-2008 12:14 PM

You could change your pinion to something like a 14 tooth. When I went from a 14 tooth to a 17 tooth I noticed my run time was reduced considerably.

All split packs will be about the same. That said, I get 45 min to an hour out of my 6 cell 1500's.

iceman320 06-29-2008 12:35 PM

ok guys I get about 15min out of my 8cell split pack if I change my pinion gear how much longer will I be able to run for? I will see how much it weighs later. Right now I'm thinking about buying a different chassis to put the drive train on.

Harvo 06-29-2008 01:49 PM

Sounds like you have a bad cell or pack. Did you break them in with a nice long slow charge? Those batteries shouldn't be charged at more than a 1 amp rate (or less if possible) for the first several charges.

iceman320 06-29-2008 10:20 PM

I charged it at 1.5 amps like tcs said. but I think your right about having a bad pack cause it charges for like five minutes and then the light on my charger starts blinking, so I think that I will have to buy another one and see what happens.


All times are GMT -6. The time now is 12:07 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com