Crawlmaster run times, and tuning tips needed
 

Just put in a HH Crawlmaster 1000kv in place of my Tekin 55T.
AX 10, 5.9lbs, HB Rovers.
Mamba Max, lowest timing, punch control disabled.
14T Pinion, 87T Spur.
12 cell Elite 1500's

Just looking for any tips on tuning this set up, (1st brush-less) and what I can expect for run times.
Thanks in advance.

gear it low and slow, and your runtimes will be pretty long. Should be in line with the 55t depending on how you drive. If you crawl around it will be nice and long, but if you start hammering down you could whittle it to 15 or 20 minutes.


Everything else sounds good. Just make sure it isn't rubbing the tranny case.

Thanks John"thumbsup"
The torque on this thing is INSANE!:shock::shock: