Integy 55t lathe or Integy 50t or 55t pro crawler
 

will i notice a difference between any of the three as far as longevity and power is concerned. ill be running a cc mamba max pro and a 3s. any help is greatly appreciated ty

The lathe will be your best bet. Not sure what the Pro is your talking about though? Life of the motor depends on how you take care of it, voltage your running, gearing, ect....

the lathe motor will be better cuz the magnets are stronger and with the right amount of current will provide better torque and rpm per volt applied

the integy pro crawler is a v10 or v11. the v10 is handwound, v11 is machine wound. really hard to say the difference you will feel with them. i have a v11 35t and love it.

ill be putting them on hr axles with stock gearing (until they break then gooan put in some berg stuff ). if that makes a difference

If ya are going integy, just get the cheap ones. Why else would ya be buying integy?

The V 11 is way better than the cheaper 18 dollar one. I have the v11 in my rig and a cheap one in my sons and the difference is very noticeable."thumbsup"

the integy motors are actualy pretty decent. really its just integy aluminum parts you need to worry about.

Re: Integy 55t lathe or Integy 50t or 55t pro crawler
 

How about SCM5501V2 ??

Re: Integy 55t lathe or Integy 50t or 55t pro crawler
 

I run an Integy 55T lathe motor with a 3S lipo. It has been a great motor and I plan to replace it with the same model when it dies.

Re: Integy 55t lathe or Integy 50t or 55t pro crawler
 

Oh ok how long have you had it and how long has it been working for with the 3s

Re: Integy 55t lathe or Integy 50t or 55t pro crawler
 

Ok I know this is an old thread but I have to agree here. I have a used V11 35t in my C1 and it works great on 3s. Keep in mind this is with 4.19" pitbulls. Been running it since January and never had an issue at all. Noticeably more torque than the used v10 50t I got with it (might need a rebuild?). I will be hanging on to this one and rebuilding it when it dies "thumbsup"

Re: Integy 55t lathe or Integy 50t or 55t pro crawler
 

I've been running a pair of the 35T lathe motors on 4s in my scx10 that have only about 5 hrs. runtime and so far, so good.