| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
01-08-2011, 11:35 AM
| #1 |
| I wanna be Dave Join Date: Nov 2008 Location: Where freedom is earned.
Posts: 2,011
|  What are your MOA FXR settings.
Just curious what everyone else is running for them. I have both FXRs set to these settings. led 1: Drag brake, = 10 led 2: Reverse strength, = 11 led 3: Current limiter, = 1 led 4: Push control, = 1 led 5: Reverse type, = 2 (instant rvrs) led 6: Voltage cut off, = 3 (3s lipo) |
|  |
| Sponsored Links | |
| | |
|
01-09-2011, 06:47 AM
| #2 |
| Pebble Pounder Join Date: Dec 2010 Location: St. Lawrence County NY
Posts: 147
|
I have mine set very similar to yours: led 1: Drag brake, = 7 led 2: Reverse strength, = 11 led 3: Current limiter, = 1 led 4: Push control, = 1 led 5: Reverse type, = 2 (instant reverse) led 6: Voltage cut off, = 2-3 (depending on which pack I'm using) |
|
| |
|
01-09-2011, 01:24 PM
| #3 |
| I wanna be Dave  Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
|
Mine is similar also but I use a hotwire so I dont know how that compares to the pit tuning. The only difference in those settings that I have is that my front esc has less drag brake than the rear. I think its like 5 on the front and 10 on the rear. It helps out on steep downhills to have the front roll out a little bit so you dont go over the front...I havent noticed it rolling backwards on uphills either.
|
|
| |
|
| |
Linear Mode
