01-24-2011, 02:13 PM | #1 |
Quarry Creeper Join Date: Dec 2009 Location: Hughson, CA
Posts: 233
| Goat 3s/Brushed?
I have a chance to pick up a goat 3s for 80$ after a fresh rebuild, because somebody thought it was water proof. I would like to run a brushed set up is this a good deal? Are the glitching problems mainly with brushless motors? My rig is an ax-10 comp based crawler with stock gears in the building stages moving into electronics. Thanks for any input.
|
Sponsored Links | |
01-24-2011, 03:01 PM | #2 |
RCC Addict Join Date: Aug 2009 Location: Earth?
Posts: 1,698
|
It will work with brushed motors. I think the limit is 33 turn.
|
01-24-2011, 03:07 PM | #3 |
Quarry Creeper Join Date: Dec 2009 Location: Hughson, CA
Posts: 233
|
I am worried about the glitching issues that I've heard about, but it was with brushless motors is it different with brushed? I just like to get the 3s capability for a little cheaper.
|
01-24-2011, 03:15 PM | #4 |
Pebble Pounder Join Date: May 2009 Location: farmington crawler capitol
Posts: 149
|
good luck with the goat 3s i just sent mine back for glitching i tried two different motors still wont work right if i was you i would get a TEKIN |
Thread Tools | |
Display Modes | |
| |