| |
02-08-2011, 08:48 PM
| #1 |
| SCALE PERFORMANCE PARTS   Join Date: Oct 2007 Location: Cedar Park
Posts: 5,453
|  Servo gear reduction?
Anybody know what typical gear reduction is in a servo from the motor to the output?
|
|  |
| Sponsored Links | |
| | |
|
02-11-2011, 10:19 AM
| #2 |
| Newbie Join Date: Jun 2010 Location: Shippensburg
Posts: 10
|
Well since nobody has answered I tore apart an old servo and started counting teeth. Starting with the motor shaft gear... 59:8 = 7.375:1 48:9 = 5.333:1 43:13 = 3.308:1 45:14 = 3.214:1 Looks to be a final reduction of 417:1 This was a Cirrus CS704MG aka CKRC Wiggle servo BTW. |
|
| |
|
02-11-2011, 03:59 PM
| #3 |
| Pebble Pounder Join Date: Jun 2010 Location: ocala
Posts: 121
|
Do you mind if I ask, Why
|
|
| |
|
12-10-2013, 10:26 AM
| #4 |
| Newbie Join Date: Feb 2013 Location: wallsend
Posts: 2
| Re: Servo gear reduction?
what tooth spline is on the cirrus 704mg pse , i need a new horn and have no idea what it is ,
|
|
| |
|
12-10-2013, 10:35 AM
| #5 |
| RCC Addict Join Date: Mar 2013 Location: Oklahoma City
Posts: 1,685
| Re: Servo gear reduction?
count the teeth on your servo output gear then get either a 23, 24, or 25 to fit
|
|
| |
|
12-10-2013, 06:46 PM
| #6 | ||
| I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: Servo gear reduction? Quote:
 Quote:
 | ||
|
| |
 |
| |
Linear Mode
