03-13-2011, 09:19 PM | #1 |
Pebble Pounder Join Date: Jan 2006 Location: Chattanooga
Posts: 139
| Novak goat 3s Q
Probably a stupid Q but I have been outa the hobby a while.Bought a losi comp crawler with novak goat 3s 21.5 ballistic castle bec and hitec 7955tg and 225 mg dig servo.spektrum dx3e radio.Why is the red wire in the three wire bundle from esc to spektrum reciever removed.Pin is pulled out and taped back.this wire plugs into throttle on esc.Sorry if it's a dumb q but brushless was brand new when I quit r/c.Thanks in advance.
|
Sponsored Links | |
03-13-2011, 09:30 PM | #2 |
Pebble Pounder Join Date: Jan 2006 Location: Chattanooga
Posts: 139
|
I am thinking it is because I don't need power a t the receiver for servos?Because of the bec? |
03-13-2011, 10:06 PM | #3 |
RCC Addict Join Date: Jul 2008 Location: San Diego
Posts: 1,144
|
You are correct!
|
03-13-2011, 10:14 PM | #4 |
Pebble Pounder Join Date: Jan 2006 Location: Chattanooga
Posts: 139
|
they have this wire pulled outa the plug at receiver,think it would be better to eliminate completely for gliching purposes?
|
03-13-2011, 10:26 PM | #5 |
Pebble Pounder Join Date: Jan 2006 Location: Chattanooga
Posts: 139
|
What the hell can't hurt.......gone
|
03-13-2011, 10:31 PM | #6 |
Quarry Creeper Join Date: Feb 2009 Location: ewetah
Posts: 315
|
I don't know, but you might still need that red wire for programing via computer. I don't know if novak has a programmer for the Goat escs.
|
03-14-2011, 05:59 AM | #7 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| |
03-14-2011, 08:37 AM | #8 |
Rock Crawler Join Date: Oct 2010 Location: triad
Posts: 634
|
yep, you made a mistake by removing it completely! You will need it to program the ESC. However, with that said, when i had my Goat 3s (before it had a bad Mofset) it ran great just as it was. So i am hesitant to hook it up and further "tune" it. That ESC was designed for the LCC and Ballistic motor, so..... i say just enjoy it. |
03-14-2011, 07:18 PM | #9 |
Pebble Pounder Join Date: Jan 2006 Location: Chattanooga
Posts: 139
|
Thanks guys.I just pulled the pin out of each end of the cable connector all I have to do is push the wire and pin back in each end.Hopefully I shouldn't need it anyway.
|
Thread Tools | |
Display Modes | |
| |