|
| LinkBack | Thread Tools | Display Modes |
03-14-2011, 07:53 PM | #1 |
Rock Stacker Join Date: Jan 2011 Location: Sundre, Alberta
Posts: 92
| having some difficulties
so i have what started as an ax10 rtr, its got a spv-1 chassis, xl-5, stock reciever, stock servo and 3000 mah nihm 7.2 volt. now to my problem my truck has been glitching, stopping completely on the rock pile and just being lame in general.... when it stops moving completely , the light on the esc still goes, but the truck just sits there. when i wiggle the reciever and esc the truck glitches then starts going again. i have full batteries in the reciever and the truck, please help!! |
Sponsored Links | |
03-14-2011, 08:00 PM | #2 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
|
Does the RX light go out when this happens? My guess is "yes", this means you need a BEC. |
03-14-2011, 08:05 PM | #3 |
Rock Stacker Join Date: Jan 2011 Location: Sundre, Alberta
Posts: 92
| |
03-14-2011, 08:36 PM | #4 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
|
Better bet is just get an external BEC. Most here, as do I, run the CC BEC. To upgrade the ESC as you're asking, you can buy a lot of BEC's. |
03-14-2011, 08:41 PM | #5 |
RCC Addict Join Date: Apr 2010 Location: Ringwood
Posts: 1,233
|
i would say check conections and the check the little gold pieces in the connector check all the electronics for loose stuff and fix it and maybe it might be the reciver |
03-14-2011, 08:41 PM | #6 |
Rock Stacker Join Date: Jan 2011 Location: Sundre, Alberta
Posts: 92
|
very true, im just bad at wiring i swapped my xtal and it seems to go good now, but i only played with it for about 10 minutes thanks for the help
|
03-14-2011, 09:03 PM | #7 |
Pebble Pounder Join Date: Jan 2011 Location: augusta
Posts: 133
|
I was having that same issue I bought a new rx tx and solved it !! and I was running a ccbec with my stock rx and tx and it was acting up The fxr I added before the rx change and it still was acting up!!!!! So I went and got the new rx tx and no problems since |
03-14-2011, 09:09 PM | #8 |
Rock Stacker Join Date: Jan 2011 Location: Sundre, Alberta
Posts: 92
| glad to know that you fixed your prob! i might just junk the old stuff and go 2.4! |
03-15-2011, 08:38 PM | #9 |
Rock Stacker Join Date: Jan 2011 Location: Sundre, Alberta
Posts: 92
|
so i thought the problem was my xtal because it worked fine for awhile....now its crapping out again! so now the xl-5 makes a weird sound when going forward and is way slower than it is in reverse. it also seems that when i climb something the truck powers out and stops and wont go until i pick it up and run it without any resitance on the wheels ( servo still works when this happens) any help would be appreciated Last edited by bwm8142; 03-15-2011 at 08:41 PM. Reason: fixin it up |
Tags |
ax10, glitching, help noob |
| |