M2 Dig and Novalink Hey All, don't know how many of you use the novalink, however, I am having a very small issue.. all of my settings save and retain in the ESC except for Voltage cutoff... it always goes back to "Off" is it the same on everyon that uses it, or is this isolated to me? |
you had better luck than i did, my Novalink didnt work at all..... |
We're still working on an update that address's a few issues. Be sure you do not update the ESC firmware. If you did already and it's working, no problem. But if you haven't don't. :) Shoot me an email with your serial number: csuangka@teamnovak.com Thanks Charlie |
does anyone know of a patch for the novalink to work with 64bit windows 7 have installed a few times the green light comes on the link and when i plug it into the esc it shows a sequence of lights ending with yellow and red leds lit up and both dig leds on solid shows that i have no connection to esc and will not reset and connect to esc .......the hole time it shows esc disconnected |
You're best bet is to not use the Novalink software with your ESC. It has a nasty tendency to fry the M2. Your M2 should have the latest firmware and programming isn't too hard with the blinking lights. A tip on programming: Use two people, one to watch the lights and one to read. |
Agree, m2 and the NovaLink are not happy right now. Looks like we'll have it sorted shortly. :) Sorry for the trouble. |
Quote:
just wated cash on the darn link then i guess we i'll hold out for a patch to come out hope it dont take to long thanks guys |
All times are GMT -6. The time now is 03:10 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com