07-22-2011, 08:49 AM | #1 |
Scale Detail Engineering Join Date: Apr 2010 Location: Turtle Island
Posts: 5,573
| extend bec wires?
I need a few more inches from my BEC wires in order to mount the electronics where I want them. Can I just clip the red and black wires and solder in a few inches of wire to extend them? I tried a servo extension that I had but it didn't work... maybe it's bad or perhaps it didn't work because the rc4wd winch is a motor and not a servo? |
Sponsored Links | |
07-22-2011, 09:26 AM | #2 |
Rock Crawler Join Date: Jul 2009 Location: Little Rock, Arkansas
Posts: 542
|
Extending them should be fine, just be sure to use the same, or very close to the same, gauge of wire.
|
07-23-2011, 06:23 AM | #3 | |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Quote:
Use same or larger sized wire (same or smaller "ga" number). As to your comment about it being a motor and not a servo, servo's have a motor in them, so basically the same. | |
Thread Tools | |
Display Modes | |
| |