JR ds8711 I have a ds8711. I had it in my wraith...it would shut the whole truck down if it got in any bind. mamba max pro esc. noticed that there was a lot of play in the servo mount....all ears busted off case....then searching for parts i see its aircraft only.... So what does a guy do ? just junk it did I burn it up? worth putting new case on? |
The BEC in the Mamba Max Pro is only three amps, 8711 (which is a very popular crawler servo) draws about ten amps in a bind. You need to add a Castle BEC, that will stop the shutting down issue and will be a must with any decent servo you run. So, buy a new case and a BEC and have fun. |
Quote:
Check out ServoCity for parts. |
servo city didnt have the parts...but its all good info thanks |
If you're in the USA, I know Tower Hobbies has a reasonable selection of parts, you can also try the Mfr direct. PS, I use #10 steel flat washers between the screws & the servo mounts to spread the loads to prevent breakage. Cheap & easy. |
http://www.horizonhobby.com/Products...odID=JRPSC8711 http://jrradios.com/Products/Default...odID=JRPSC8711 I used Horizon for the one I had to replace last year. |
All times are GMT -6. The time now is 08:09 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com