| |
11-11-2011, 05:44 PM
| #1 |
| Rock Stacker Join Date: Jun 2011 Location: Coquitlam
Posts: 58
|  Help Wiring up LED's
I have never done this stuff B4, I have no issue with soldering im quite good with electronics in general.... I guess my question is can I remove/modify the stock LED's in my wraith for some high powered Bright whites i can get at HomeDepot or some other joint..... Can I use the same light controller or must i get something else? Thanks in advance Elliott |
|  |
| Sponsored Links | |
| | |
|
11-11-2011, 05:57 PM
| #2 |
| I wanna be Dave  Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
|
If the specs on the LED's are the same then it will work fine. I dont know how they do it, is the voltage controlled by the controller or is there a resistor wired on each LED? You have to figure that out first.
|
|
| |
 |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
