GT3 no enter or trim buttons?

[JKMotorsports]

Here is the history. I have had a gt3 connected but haven't really run my rig with it yet. The other night i got my 8ch rx in and decide to try it out. after installing i had not steering control. Both escs worked fine. I fiqured it was the firmware still being for a 3ch so i updated.

Now my enter button or any of my trim buttons except for one do nothing. I reloaded my old firmware and still have the problem.

Any ideas? I was only getting 10.8v on the colntroller as the scroll still works. Also the batteries were cold as they were sitting in a bag in my car and it is -12deg cel. out.

[losikid]

Originally Posted by JKMotorsports

Here is the history. I have had a gt3 connected but haven't really run my rig with it yet. The other night i got my 8ch rx in and decide to try it out. after installing i had not steering control. Both escs worked fine. I fiqured it was the firmware still being for a 3ch so i updated.

Now my enter button or any of my trim buttons except for one do nothing. I reloaded my old firmware and still have the problem.

Any ideas? I was only getting 10.8v on the colntroller as the scroll still works. Also the batteries were cold as they were sitting in a bag in my car and it is -12deg cel. out.

load an previous version like 0.3.0 fw then reload the 0.4.1...

here's a download link for 0.3.0 (right click, click save as)

http://www.overkillrc.webs.com/GT3B-...-ch3-0.3.0.s19

[losikid]

when changing channel version within the same set of firmware causes issues because your either covering up or corrupting the model memory area

[JKMotorsports]

You are the king! Thanks a ton!!!