|
| LinkBack | Thread Tools | Display Modes |
02-22-2012, 07:01 PM | #1 |
Pebble Pounder Join Date: Jan 2012 Location: middle earth
Posts: 116
| running leds and cree lights from fourth channel on receiver?
I have an extra receiver channel on my receiver. Ok...the plan is to put several lights in. Id like to put in (all 5 mm led) four white rock lights...four red brake lights...one or two blue safety lights. I also wanna put in two t15 cree lights for headlights (these are normally used to replace license plate lights on a car). Question is can I wire all these together to a switch and run them from the fourth channel on the receiver and power them all? Or should I seperate the leds from the cree lights and run a seperate power source to each ( the ten leds...and one for the cree)? BTW Im running 3s 30c 2800 mah lipo
|
Sponsored Links | |
02-22-2012, 08:37 PM | #2 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Re: running leds and cree lights from fourth channel on receiver?
What you need is an RC switch, Heyok is a vendor on here and he makes all kinds of switches and lighting controllers...Hit him up and he can get you what you need. As far as all of your lighting needs, you will have to do some calculating and figure out the best way to proceed. It makes a big difference if you plan to wire up your own LEDs or if you are going to buy prefabricated ones that RC manufactures make. |
running leds and cree lights from fourth channel on receiver? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
anyone used a mini q5 cree flashlight for lights? | shaggy2112 | Electronics | 7 | 11-16-2012 05:42 AM |
Receiver LEDs and winch question | Tom_Swanson | Electronics | 1 | 12-02-2010 05:16 PM |
Cree LEDs for Headlamps | footprint | Electronics | 0 | 11-17-2008 05:34 AM |
Lights running of RX | brendan h | Electronics | 4 | 09-06-2006 03:24 AM |
| |