| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
05-13-2012, 05:35 PM
| #1 |
| Pebble Pounder Join Date: Apr 2010 Location: Guam
Posts: 171
|  Waterproofing A Tekin Redline
Does anybody have a walkthrough on this procedure? I opened up the motor and the sensor board is in 2 pieces, one on the inside of the motor and the other on the outside.
|
|  |
| Sponsored Links | |
| | |
|
06-01-2012, 04:39 PM
| #2 |
| Pebble Pounder Join Date: Apr 2010 Location: Guam
Posts: 171
|  Re: Waterproofing A Tekin Redline
????
|
|
| |
|
06-01-2012, 06:43 PM
| #3 |
| RCC Addict  Join Date: Nov 2011 Location: the not so white north
Posts: 1,299
| Re: Waterproofing A Tekin Redline
All I did to mine was coat the sensor wire where it goes into the motor and the terminals and board that is showing with liquid electrical tape.. I have run it through water and mud with no issues. Although I have not tried putting it into a bathtub as I usally shoot through the water and mud. Not sure if there are better ways but worked for me.
|
|
| |
|
Waterproofing A Tekin Redline - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tekin Redline Motor's | sally1800 | Electronics | 7 | 08-09-2011 09:47 AM |
| |
Linear Mode
