Want to go brushless in my LNC, what works best? Motor/esc?
 

My motor in my Lnc is about to go, so I want to go brushless. What are people running? Is there a good esc/motor combo out there?

Re: Want to go brushless in my LNC, what works best? Motor/esc?
 

Castle Mamba Max Pro and your choice of sensored brushless motor, I personally really like Tekin motors. Not sure what turn the LCC guys are running but I would check in their section.

Re: Want to go brushless in my LNC, what works best? Motor/esc?
 

I've done a lot of searching around and the mamba max pro is the general consensus on ESC. Motor is all personal preference, I've read a wide variety of motors being used but sensored is a must have from what I understand.

Re: Want to go brushless in my LNC, what works best? Motor/esc?
 

MMP and a tekin 13.5 turn is what my buddy runs and it works great.

Re: Want to go brushless in my LNC, what works best? Motor/esc?
 

MMp and a tekin 18.5 its what ive had in my LCC and its perfect

Re: Want to go brushless in my LNC, what works best? Motor/esc?
 

mamba max pro and a novak ballistic 17.5 w/ 14t pinion is what I'm running and love it. I've tried the 13.5(12 and 14T pinions) and it's great as well except it lacks a little torque that the 17.5 gives me, it has the wheel speed the 17.5 lacks but the 13.5 get's a little warm after a 8-10min run (140 ish).
The 17.5 on the other hand DIDN'T have the wheel speed I wanted... until I set CHEAT MODE on the MMP:shock: I forget exactly where I set the RPM for cheat mode but just over half throttle the cheat mode timing of 30 degrees kick's in giving me around the wheel speed of the 13.5 when needed:mrgreen: as long as I'm not over half throttle to much using cheat mode the 17.5 run's cool(110-120 average) for easy back to back packs if I wanted.

John


Crap... I was thinking LCC not LNC... your trans is completly differnt from my LCC... nothing I 've said applies to your LNC trans:oops: