tekin rspro pissing me off
 

installed a cc bec and now the 3 leds light up when i plug in the battery...this is before i turn it on. turn it on and all leds flash and dont shut down until battery is unplugged. also when turned on it chimes only twice. doesnt do anything at all, checked wiring and all looks good, im at a loss.

Re: tekin rspro pissing me off
 

update, its because the rspro internal bec isnt powering the reciever. no idea how to solve this??

Re: tekin rspro pissing me off
 

Did you disconnect the red wire from the ESC to the receiver? You don't have to cut it off just pull the pin out of the shell.

Did you solder the power (battery) wire of the BEC to the battery posts on the ESC?

Leave the ESC switch on, power it up by plugging in the battery.

If only the 1,2,3 led light up you may need to recallibrate the ESC to the radio.

Re: tekin rspro pissing me off
 

Are you using the CC BEC to power only the servo? Then you need the ESC's BEC to power the receiver.

If you are powering the receiver from the BEC then remove the ESC's red wire from the plug shell.

Re: tekin rspro pissing me off
 

yeah i found the problem, the esc power was loose inside of the plug. i changed the plug out and it works.