| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
08-08-2012, 08:17 PM
| #1 |
| RCC Addict Join Date: Jun 2011 Location: Gilbert, AZ
Posts: 1,634
|  AR-3 receiver with 7.4V?
Has anybody run an Axial AR-3 receiver with a BEC at 7.4V running into it? Can the receiver take the higher voltage? It didn't seem to mind 6.0V. Thanks |
|  |
| Sponsored Links | |
| | |
|
08-08-2012, 09:44 PM
| #2 |
| RCC Addict  Join Date: Oct 2011 Location: British Columbia
Posts: 1,487
| Re: AR-3 receiver with 7.4V?
From what I've read, 6v is the max on that Rx.
|
|
| |
|
08-08-2012, 09:50 PM
| #3 |
| RCC Addict Join Date: Jun 2011 Location: Gilbert, AZ
Posts: 1,634
| Re: AR-3 receiver with 7.4V?
Kinda what I though but wasn't sure.
|
|
| |
|
12-31-2014, 09:02 AM
| #4 |
| Quarry Creeper Join Date: Sep 2014 Location: UK
Posts: 256
| Re: AR-3 receiver with 7.4V?
Resurrecting an old thread here, but I read others had done this with no issues, and I have also done this without any issues yet. I set my castle BEC @ 7.4 for the Savox servo I have and ran it through my Yeti's AR3 RX. |
|
| |
|
AR-3 receiver with 7.4V? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trying to get the receiver out of the receiver box | rock-gobbler 77 | Electronics | 6 | 03-03-2011 03:03 PM |
| receiver | lemons17771 | Newbie General | 1 | 01-22-2009 09:53 AM |
| receiver | wheeler | General Crawlers | 7 | 05-13-2004 08:33 PM |
| |
Linear Mode
