10-22-2012, 11:11 AM | #1 |
Pebble Pounder Join Date: Sep 2012 Location: Clarksville
Posts: 138
| Hitec Servo Question
The steering servo on my wraith has some side to side movement in the shaft,so i decided to replace it with a new one.I picked up a Hitec HS-5665MH digital servo at my Lhs and i noticed on the instructions it says do not use bec system built in most 2 ch.receivers make sure you bypass the bec for stable operation.Well i thought i would try anyway to see if it would work,well it seems to work fine.What could happen if the bec in the receiver is not bypassed?By the way i'm using all of the stock electronics except for the steering servo.
|
Sponsored Links | |
10-22-2012, 11:49 AM | #2 |
Pebble Pounder Join Date: Jun 2012 Location: Canada
Posts: 179
| Re: Hitec Servo Question
Your RX shouldn't have a bec... Your ESC might. Its common practice to use a more capable BEC then the one included in most ESC's. I would assume this is what they mean. That servo only draws 3 amps at stall, so it should be fine, but adding a castle BEC will never hurt. |
10-22-2012, 12:04 PM | #3 |
I wanna be Dave Join Date: Dec 2008 Location: Madrid, IA
Posts: 2,015
|
Some receivers do have a built in bec that merely reduces the rx pack voltage down to usually 6v and that's what it meant by not using the rx bec Sent from my iPad using Tapatalk |
10-22-2012, 12:23 PM | #4 |
Pebble Pounder Join Date: Sep 2012 Location: Clarksville
Posts: 138
| Re: Hitec Servo Question
Good deal,thanks a million folks for clearing it up!
|
Hitec Servo Question - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
hitec servo glitching and a servo horn question | m1009cucv | Electronics | 5 | 08-18-2012 11:22 AM |
Hitec HS65MG Servo Question | Sh0rtBus | Losi Micro-Rock Crawler | 4 | 06-06-2012 12:42 PM |
QUESTION about hitec servo | tinycrites | Electronics | 4 | 02-28-2012 03:35 PM |
Hitec servo question | badBKO | Electronics | 1 | 01-16-2010 09:46 PM |
Hitec servo question | Raguvian | Electronics | 2 | 09-04-2009 04:39 PM |
| |