|
| LinkBack | Thread Tools | Display Modes |
11-19-2012, 09:31 PM | #1 |
Rock Crawler Join Date: Mar 2011 Location: hampton
Posts: 984
| mamba micro pro wont calibrate
iv tried everything to make this thing work. epa's set to 100% trim set to 0. when i try to calibrate it all i get is the start up tone and then yellow and green flashing. i dont think its a radio issue, my ae2 will go right into calibration no problem. i want to run the micro in my scx10. right now i have full throttle reverse and half, maybe a little more forward, everything is set right with castle link and im running firmware version 1.38 beta. bad firmware maybe? |
Sponsored Links | |
11-20-2012, 04:49 AM | #2 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: mamba micro pro wont calibrate
Is your battery charged? Based on this..... Castle Creations | FAQ: 1/10th Scale Products (bottom of page) sounds like you've hit LVC, unless the flashing yellow & green is during calibration. May also want to try an earlier firmware, I've read some issues with newer firmwares. |
11-20-2012, 07:16 AM | #3 |
Rock Crawler Join Date: Mar 2011 Location: hampton
Posts: 984
| Re: mamba micro pro wont calibrate
its charged, even tried a couple different ones just to make sure. tried reversing the channel, and tried with 2 different radio systems. i do have the red lead pulled and have a CCbec powering the rx. that matter? |
11-20-2012, 07:34 AM | #4 |
Rock Crawler Join Date: Mar 2011 Location: hampton
Posts: 984
| Re: mamba micro pro wont calibrate
dropping the bec didnt work.
|
mamba micro pro wont calibrate - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dx3.0 wont calibrate with brake for fxr | crawler_jake | Electronics | 3 | 06-14-2010 10:28 PM |
Thread Tools | |
Display Modes | |
| |