RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Electronics (http://www.rccrawler.com/forum/electronics/)
-   -   m2 with 2 position 3rd channel? (http://www.rccrawler.com/forum/electronics/414196-m2-2-position-3rd-channel.html)

7r0y801 11-22-2012 05:58 AM

m2 with 2 position 3rd channel?
 
Hey guys. I'm a bit of a noob. Is it possible to run the nova2 dig etc with nova2 position 3rd channel. I understand i won't get all options i just want to lock the rear. Any advice appreciated

heyok 11-22-2012 11:37 AM

Re: m2 with 2 position 3rd channel?
 
Quote:

Originally Posted by 7r0y801 (Post 4027065)
Hey guys. I'm a bit of a noob. Is it possible to run the nova2 dig etc with nova2 position 3rd channel. I understand i won't get all options i just want to lock the rear. Any advice appreciated

I don't know all there is to know about that dig, but I would expect that it would work.

I make dig controllers for both two and three position channels. If you use one of my three position type digs, you would get one axle in lock in one position and 4wd in the other.

MOA Dig Controller for Two Position Channel

MOA Dig Controller for Three Position Channel

7r0y801 11-22-2012 05:46 PM

Re: m2 with 2 position 3rd channel?
 
Do you ship to Australia? I have read aloft of good things about your products. But i feel i will be wasting money on the dig controller. I might get a new radio.

heyok 11-22-2012 06:23 PM

Re: m2 with 2 position 3rd channel?
 
Quote:

Originally Posted by 7r0y801 (Post 4027794)
Do you ship to Australia? I have read aloft of good things about your products. But i feel i will be wasting money on the dig controller. I might get a new radio.

Yes, I ship to Australia!

As for the waste of money, well that's your decision. I've run both a switch type dig (the kind I make) and I have run dual ESCs using a hacked GT3B and I definitely prefer dual ESCs! Even though the GT3B is a bargain, there is still a lot of money to put out to get that running because you also need a second ESC.

My controllers will be here if you decide they are right for you.

Cheers,
Al


All times are GMT -6. The time now is 04:33 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com