| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
11-26-2012, 09:19 AM
| #1 |
| Quarry Creeper Join Date: Mar 2012 Location: Montreal
Posts: 236
|  4PL programming question
Hi all, quick question... Two ESCs and a 4PL. I have dig lock on D3 button Proportional rear on D4. I was wondering if we could have D4 starting "off" from D3. Let's say I use Dig Lock and I wanted to start from full lock to incremental speed ? For now, I have to lock digm unlock dig, then get proportional to zero, then going up. Hope this makes sense  In fact I would like to go: D3 Lock, D4 increase as straight as that Thanks! |
|  |
| Sponsored Links | |
| | |
|
11-26-2012, 11:26 AM
| #2 |
| RCC Addict  Join Date: Mar 2011 Location: Katy / west houston
Posts: 1,014
| Re: 4PL programming question
Have you watched Harley's setup videos in his 4pl tech thread?
|
|
| |
|
11-26-2012, 11:31 AM
| #3 |
| RCC Addict Join Date: Mar 2011 Location: Katy / west houston
Posts: 1,014
| Re: 4PL programming question |
|
| |
|
11-26-2012, 11:32 AM
| #4 |
| Quarry Creeper Join Date: Mar 2012 Location: Montreal
Posts: 236
| Re: 4PL programming question
I did and used it to setup my electronics, and did not see this "specific" part, I'll look at it again right now. Thanks. |
|
| |
|
4PL programming question - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Novak M2 dig ESC and Futaba 4PL programming | asian195 | Electronics | 7 | 08-11-2012 11:15 AM |
| Programming a 4PL for 4WS and Winch | Harley | Axial Wraith | 15 | 12-05-2011 11:01 AM |
| ESC Programming Question | AG74683 | Electronics | 0 | 08-25-2011 04:24 PM |
| HELP! Programming Futaba 4PL w/ Novak M2 dig | justinoiochoa | Electronics | 20 | 03-09-2011 08:54 PM |
| Anyone here know C++ programming? I have a question. | Scattman | Chit Chat | 8 | 02-21-2009 09:47 PM |
| |
Linear Mode
