|
| LinkBack | Thread Tools | Display Modes |
01-19-2013, 12:04 AM | #1 |
Rock Stacker Join Date: May 2011 Location: minnesota
Posts: 96
| Tekin 35t pro handwound on 2s?
Like the title states i'm wondering if I can run a 2s on this particular motor. I have searched and can't find any specs. I know I can only run a 3s minimum in my HD version. Any input is appreciated.
|
Sponsored Links | |
01-19-2013, 12:08 AM | #2 |
RCC Addict Join Date: Apr 2009 Location: Token's life matters
Posts: 1,836
| Re: Tekin 35t pro handwound on 2s?
The voltage limit is on the upper end not lower. I probably would not run more than 3s through it. But it should run fine on 2s.
|
01-19-2013, 09:07 AM | #3 |
I wanna be Dave Join Date: Apr 2007 Location: Arlington, Washington
Posts: 2,303
| Re: Tekin 35t pro handwound on 2s?
3s no problem, just more frequent rebuilds.....4s is usually fine too, but even more frequent rebuilds......some nuts run 5s, works but plan on rebuilding daily. Later EddieO |
01-19-2013, 01:52 PM | #4 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: Tekin 35T pro handwound on 2S?
As stated you're fine, I ran quite a few 3S LiPO packs through the same motor. Keep an eye on it.....no real issue. Never tried more than a 3S LiPO through it though. More voltage/load, more maintenance. |
01-19-2013, 10:03 PM | #5 |
Rock Crawler Join Date: Dec 2009 Location: Redding
Posts: 705
|
I run the Tekin handwound 35t in my 8.5 pound G6 rig. 3s all day long with no problems at all. Just did the first rebuild after 5 G6 runs. About 2 or 3 hours per run on average.
|
Tekin 35t pro handwound on 2s? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tekin fxr and 35t handwound motor? | Cypher | Axial SCX-10 | 10 | 09-06-2011 10:00 AM |
tekin combo pro handwound 55t or 45t or 35t | guidetti_angelo | Electronics | 14 | 01-22-2010 07:03 PM |
Thread Tools | |
Display Modes | |
| |