|
| LinkBack | Thread Tools | Display Modes |
02-18-2013, 11:17 AM | #1 |
Quarry Creeper Join Date: Nov 2007 Location: WNC
Posts: 456
| Plugging 4mm bullets into regular bullet connectors?
My stock Twin Hammers motor died this morning. Wasn't even running the rig. Anyways... I have a 35t rc4wd motor that works but it has 4MM Bullets while the Tazer ESC has regular bullet style connectors. Can I plug the 4mm bullets into the regular bullets on the ESC and run it for a few packs without destroying anything? The motor is out of my daughters rig so it needs to stay how it is. I searched. And searched.... And searched.... Thanks. |
Sponsored Links | |
02-18-2013, 04:09 PM | #2 |
owner, Holmes Hobbies LLC Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
| Re: Plugging 4mm bullets into regular bullet connectors?
You will be fine as long as the push fit is tight. I put a BRXL in my twin hammers and shoved the stock bullets into the 4mm bullet of the BRXL, works without a hitch.
|
02-19-2013, 01:01 PM | #3 |
RCC Addict Join Date: Dec 2007 Location: Moncton, NB, Canada
Posts: 1,962
| Re: Plugging 4mm bullets into regular bullet connectors?
That's how I have it on a couple rc's. I just take some pliers and flatten the regular bullet just a little bit to get a tight fit, then I shrink wrap it up. Make sure however to put the piece of shrink wrap on the wire before pressing them together.
|
02-20-2013, 05:51 AM | #4 |
Quarry Creeper Join Date: Nov 2007 Location: WNC
Posts: 456
| Re: Plugging 4mm bullets into regular bullet connectors?
Thanks for the information fellas. I figured it would have been fine but just want to make sure.
|
Plugging 4mm bullets into regular bullet connectors? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bullet connectors or? | Fattymojo | Newbie General | 5 | 07-05-2010 10:27 AM |
| |