RS Pro W/ Roc412 help
 

I am experiencing an issue when applying throttle to the ESC. The truck sputters a bit then jumps forward. THis happens 90% of the time...:evil:

Sometimes it will crawl nice and smooth without issues... I have tried to reseat the sensor cable, checked to make sure the rx is good. nothing is hot or has gotten hot... It's been this way since I took them out of the box.

Can someone please help me diagnose this. I am at a loss...:cry:

Thanks!

Re: RS Pro W/ Roc412 help
 

You got a bec? Had the same problem w/the mmp/tekin 13.5 and added a bec it stopped.

Yeah I do!.... I'll get it wired up and hope that fixes the issue... Thank you!


Sent from my iPad using Tapatalk HD

Re: RS Pro W/ Roc412 help
 

Make sure the ESC is set to either Dual Mode or Sensored Only as well. I have an RS with a Redline 13.5 and it's smooth as butter on startup.

I have plans to wire up the bec this week just to be sure but I think I may have fixed the issue...

I tried to ensure all sensored & 3s liposettings were enabled;they were and - still didn't fix it.

I tried different rx- didn't fix it

I tried replacing batteries in Tx - didn't fix it

I tried both dm2 and sensored only - didn't fix it

I tried different cutoff voltage settings - didn't fix it

Finally, I decided to save my setup I wanted, then I rolled back to older firmware version then rolled back again to 223 firmware, reloaded saved setup profile and the problem has not returned after a 45min run...

Just wanted to post what fixed the issue for me should someone else have this issue.

If the issue returns, I'll post it up.

Thanks guys!



Sent from my iPad using Tapatalk HD