Receiving Problem

[cherokeexjwheeler]

My buddy just got a new scale rig, scx10 i believe, he bought it used off of ebay..however when you turn the rc on, it doesnt connect..have taken it apart, tried rebinding it, disconnecting and re connecting wires.. the radio system and receiver are; radio: CY300 FHSS EPA, receiver: XY3000 FHSS.

Thanks

[Charlie-III]

We're assuming the batteries in the TX are good and the pack in the rig are charged?
Is there an on/off switch on the ESC?

[cherokeexjwheeler]

Originally Posted by Charlie-III

We're assuming the batteries in the TX are good and the pack in the rig are charged?
Is there an on/off switch on the ESC?

yes they are brand new, and the battery pack is charged. the on off switch was cut and soldered together.

[Charlie-III]

Make sure the ESC & servo wires are correctly installed into the RX, usually the dark wire (black or ?) is towards the outside edge.
What ESC?
Do any lights come on? If so, I would rebind the RX to the TX (I know you already did that...).

Is this the radio??... http://etronix-rc.com/manuals/ET1105.pdf

If nothing else works, contact the seller.

[cherokeexjwheeler]

Originally Posted by Charlie-III

Make sure the ESC & servo wires are correctly installed into the RX, usually the dark wire (black or ?) is towards the outside edge.
What ESC?
Do any lights come on? If so, I would rebind the RX to the TX (I know you already did that...).

Is this the radio??... http://etronix-rc.com/manuals/ET1105.pdf

If nothing else works, contact the seller.

yes that is the radio. i cant find a binding button on it..and if i rebind the receiver, it will beep, than nothing. the lights do come on. i will check the rewiring thanks.