m2dig/mx3-x radio

[wrightwayz71]

has anyone tried to program the airtronics mx3-x to the novak m2 dig esc?
i guess i should of done some more homework b4 i bought the mx3-x radio i thought it had a 3 position switch http://www.rccrawler.com/forum/image...s/icon_cry.gif

[heyok]

Sorry to hear you found out too late about your transmitter's third channel.

If you aren't looking to upgrade your transmitter, I make a dig controller that will work on a transmitter with a two position third channel:
MOA Dig Controller for Two Position Channel

[Charlie-III]

HeyOK makes a lot of crawler stuff, never tried any (sorry HeyOK) but I can't remember a complaint with the parts or support. I believe you would only need one set of ESC output wires (or, maybe wire it up as "high power"....read the M2 instructions) with the HeyOK unit.

A similar option is a WantAmix from LosiKid/OverkillRC (link in my sig). That is what I use on my Futaba 3PM-x to run dual ESC's in my 2.2 Bully. I see no reason it wouldn't work on the M2 dig since it has 2 sets of inputs to it.

Both units (HeyOK & LosiKid) do basically the same thing on the same radio. They do it differently at slightly different prices.
Read the specs on each, then get one, they will both work well for you.

PS, as to the M2 dig, good luck with it. I had one, but was not impressed after using Tekin FX-R's and Castle Creations ESC's. The M2 works, just not the way I wanted/was expecting. I sold it and went to dual ESC's in my 2.2 XR-10.
Read the M2 directions really well BEFORE hooking it up so you don't create issues with it.