Sidewinder Micro firmware i searched -- so i just received two CC Sidewinder Micros and when i connected them to the Castle Link, i found that a Firmware Update is available. question is, should i update from 1.32 to 1.39 Beta? |
Re: Sidewinder Micro firmware I would leave them where they are. I believe I back dated mine to 1.28, some later versions were so-so for crawler use. |
Re: Sidewinder Micro firmware should i get the 1.28 too? would run 2 x 45T HH motors with 3S on an XR10. |
Re: Sidewinder Micro firmware odd, I checked mine and I also run the 1.28V, its on a MRC with a brushless motor...not sure why I have it on the version...but from what I remember, it does make it crawler friendly. |
Re: Sidewinder Micro firmware hmm... makes me want to change my firmwares to v1.28 but if there's nothing wrong with what i'm running now, i should just go ahead and try it. anybody else here using v1.32? |
Re: Sidewinder Micro firmware Im using 1.32, but form the other responses I'm going to try 1.28 for kicks. |
Re: Sidewinder Micro firmware im on 1.28 in a og sidewinder was on 1.32 with a mmp and it was weird had problems calibrating the it, no forward power then it would work again.switched to 1.28 after some searching and fixed the weirdness i had 1.32 . just get 1.28 and forget about it. |
All times are GMT -6. The time now is 08:40 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com