TQi 3ch dig mod??

[wally197203]

Well I've joined quit a while ago , and a lot of my questions were answered without me asking if I looked hard enough.
Well here it goes. .. I have a Berg , with 2 Sidewinder micro sport esc, CC 10amp BEC wired directly to the servo. One red wire from 1 of the esc disconnected from the rx the other connected. as per 2nd wire diagram from Sticky's thread.

Now.. I have modded a TQi 3ch tx with a on/off button for the thumb switch.
What I want to know. Is it possible for this setup to work? I can't figure it out.

My results so far have been both esc on- CH1 esc full control. Ch2 esc button on toggles fwd/rev button off stays neutral-no control from trigger.

I've seen it work on a YouTube vid, but the guy didn't explain the wiring or anything.

I'm anxious to hit the rocks I hope I explained well enough, please help direct me . Thanks

[wally197203]

Anybody...? I'm getting the feeling there is no way to get mixing mod for this.