06-24-2013, 06:49 AM | #1 |
RCC Addict Join Date: Dec 2008 Location: Sonora, CA
Posts: 1,664
| Factory Wraith issue
My Buddy has a Wraith that all of a sudden has no throttle response forward or reverse. It does however have steering. He has tried to re-bind the radio without any results. I am thinking it maybe the ESC. I have no experience with the factory Axial ESC's at all. All of my Rigs have got after market units. All right, lets hear your thoughts.
|
Sponsored Links | |
06-24-2013, 08:52 AM | #2 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: Factory Wraith issue
Try to recalibrate the ESC to the RX, that sounds more like the issue since the steering still works (thus the RX is likely still bound to the TX). Usual calibration is: TX throttle trims to "0" TX throttle EPA's to "100%" TX on, hold full throttle, power up ESC. Hear the "chime", go to full reverse, hear the chime, go to neutral, hear the chime and then the "arming". You sometimes have to cycle the power off/on on the rig so it works. |
06-24-2013, 09:43 PM | #3 |
RCC Addict Join Date: Dec 2011 Location: Raleign
Posts: 1,439
| Re: Factory Wraith issue
You'll also get steering but no throttle when you hit LVC. I know it's a dumb question, but does it do that with a fresh battery as well?
|
06-27-2013, 03:55 AM | #4 |
Newbie Join Date: Oct 2011 Location: Texas
Posts: 27
|
Mine has had that issue too, it ended up being the batt. Plug. I took a little screwdriver and reshaped the plug to make good contact again and it worked fine after that.
|
Factory Wraith issue - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wraith Issue | My(2)Cents | Axial Wraith | 4 | 06-22-2013 06:30 PM |
Wraith ESC/Rx issue | lcbsc | Electronics | 1 | 11-14-2011 12:16 PM |
axial Wraith esc set at 50% from factory | clutchburner | Axial Wraith | 3 | 07-03-2011 10:19 AM |
Thread Tools | |
Display Modes | |
| |