07-05-2013, 01:03 PM | #1 |
Quarry Creeper Join Date: Feb 2010 Location: Knee deep in a creek with a fish on the line
Posts: 456
| single mamba micro
I am thinking about parting out my comp rig to finish two scale builds sitting on my bench. Do you think the Micro's will be ok in a scale rig running a 35t?
|
Sponsored Links | |
07-06-2013, 12:37 AM | #2 |
Proverbial threadkiller Join Date: Feb 2011 Location: Central Wisconsin
Posts: 1,453
| Re: single mamba micro
I have Micro's in both my comp rig (2.2) and my trail rig (1.9), both with 35's. But, I am geared pretty low at 14/87 in both. They run fine for me.
Last edited by Trubble; 07-06-2013 at 12:38 AM. Reason: added tire/wheel sizes |
07-06-2013, 05:21 AM | #3 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: single mamba micro
I run Sidewinder Micro Pros & Mamba Micro Pros in 2.2 MOA comp rigs with 35T motors on 3S. I think you'll be fine. |
07-06-2013, 01:06 PM | #4 |
Quarry Creeper Join Date: Feb 2010 Location: Knee deep in a creek with a fish on the line
Posts: 456
| Re: single mamba micro
Thanks guys. I thought they might be alright for crawling and a few speed bursts. Just wanted to see if anyone had had real world world experience e with the setup.
|
07-06-2013, 02:23 PM | #5 |
Pebble Pounder Join Date: Jul 2008 Location: Tamworth, England.
Posts: 124
| Re: single mamba micro
I have run a Sidewinder Micro in my CR-01 running one of my 35 turn motors on 3s with no issues at all. That was running with 2.2" rovers on trail runs etc.
|
07-06-2013, 05:36 PM | #6 |
I wanna be Dave Join Date: Jul 2009 Location: Rancho Relaxo. California. USA. Earth.
Posts: 3,292
|
A guy in my area ran a couple of them in a couple rigs, they did well. 35t's on 3s with ccbec's too of course.
|
07-07-2013, 05:53 AM | #7 |
Quarry Creeper Join Date: Feb 2010 Location: Knee deep in a creek with a fish on the line
Posts: 456
| Re: single mamba micro
Just to be clear. I am currently running two mambe micros in my comp rig. What I am looking to do, is part out the comp rig and run a single micro in each of my scale builds that will be running the HH 35t motors on 3s. I am fairly certain that a single micro will be fine but I wanted to see if anyone had run something that small with any success. I will be running stock axial tranny gearing, and a 13t pinion.
|
Thread Tools | |
Display Modes | |
| |