08-19-2013, 07:20 PM | #1 |
Rock Stacker Join Date: Dec 2011 Location: Atlanta
Posts: 93
| SV3 not working
hey, just got my Sidewinder SV3 in the mail and plugged it up to my brushed motor and it wont work. it shakes and then stops every time i pull the trigger. i checked my wiring with the one supplied in the manual and it was fine i also calibrated it several times. do i have to change any settings out of the box to run brushed? could i have gotten a defective esc?
|
Sponsored Links | |
08-19-2013, 07:32 PM | #2 |
Pebble Pounder Join Date: Dec 2011 Location: Ridgecrest, CA
Posts: 192
| Re: SV3 not working
By all means check the settings before use. I cannot remember for sure, but I seem to recall that mine came from the factory set to run brushless. Jerry
|
08-19-2013, 07:37 PM | #3 | |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: SV3 not working Quote:
If you don't have a Castle Link to program, you can use this... http://www.castlecreations.com/suppo...s_ed_guide.pdf pages 24 & 30. | |
08-19-2013, 07:45 PM | #4 |
Rock Stacker Join Date: Dec 2011 Location: Atlanta
Posts: 93
| Re: SV3 not working
ok cool, i figured it was set up for brushless, i just wasnt sure if it would auto swap to brushed mode since it was right from the box and i didnt see anything about changing to brushed mode
|
SV3 not working - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SV3 or BR-XL | Francois | Electronics | 21 | 08-30-2013 12:54 AM |
sv3 vs mmp | jcsaxial | Electronics | 11 | 04-05-2013 06:43 PM |
castle sv3 are in | tunnalram | North Dakota | 0 | 02-22-2013 02:15 PM |
Sv3... | solly98 | Axial SCX-10 | 15 | 02-02-2013 11:39 PM |
Im Working On A Working Wrecker Any Ideas? | LEDDPIPE | General Scale Talk | 7 | 12-13-2006 11:53 PM |
Thread Tools | |
Display Modes | |
| |