More than one bec?

[Tgreer]

Ok I want to make sure I get this right! Here is my list of electronics for my wraith

Mamba Max Pro ( the red receiver wire has the end cut off)
Bec at 7.4
Bec at 6.0
7950 servo
10.5 sensored brushless motor
Heyok winch control
3racing winch
3cell battery
Bypass adapter


Ok, I realize this is child's play for most you guys, but what has me messed up is two bec and my esc red wire being cut off. So, my idea is run the 7.4 bec with the adapter straight to the servo. Then run the 6.0 bec the normal way where it just plugs in the bind port on the rx to run the esc and the winch. And obviously the red wire will be disconnected on the esc since the end of it is cut off. Will this work? Or will the bec's interfere with each other?

[Szczerba]

if you directly run one bec to the servo (only signal wire from servo to RX) and the other BEC to the RX with the red wire pulled on ESC, you're good.

[Tgreer]

Originally Posted by Szczerba

if you directly run one bec to the servo (only signal wire from servo to RX) and the other BEC to the RX with the red wire pulled on ESC, you're good.

Cool! Thanks! Just wanted to make double sure before I fried something!