Bec/receiver problems.?? Help I just bought the spektrum waterproof surface receiver and a new BEC. I hooked everything up as it should be with the BEC in the bind port. It worked like a champ for two or three runs. I went to plug a new battery in and the BEC was flashing like it came unbound so I rebound it and it didn't fix the problem. I can plug the BEC in the aux port and everything works just fine. I'm not sure what changed or happened but any help would be appreciated. I have used several BEC's in the past years and nothing like this has happened before! Thanks in advance! |
Re: Bec/receiver problems.?? Help Did you remove the red wire from the ESC to the RX?? You should not have 2 power supplies going to the RX. |
Re: Bec/receiver problems.?? Help If that fixes it then why not just leave it in the auxiliary port? If you already have something plugged in there then just get a Y harness and run both to the auxiliary port. |
Yes I removed the red wire from the esc and I am running a winch. I'm going to try the Y plug should do the trick thanks for the help |
All times are GMT -6. The time now is 10:30 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com