MRC stock ESC & HS-5245MG Dead

[bigblock123]

First off Great place you Have here,Recently ran a new HS-5245mg in my stock MRC. Lasted a full day then the servo seemed to have locked up solid.Burned up the ESC as well.what did i do wrong?


Thanks

[Charlie-III]

It's this servo.... HS-5245MG Digital Mini , very low load.

Any ESC BEC should have handled it well.
Maybe there was steering binding or the servo EPA's (End Point Adjustments) were too great, thus allowing the servo to stall and overdrive the ESC BEC.

Who knows.

Danvers..... in MA??, if so:

1-Sorry about the teacher death there recently.
2-I have a customer site there (for the local electric utility).

[bigblock123]

Originally Posted by Charlie-III

It's this servo.... HS-5245MG Digital Mini , very low load.

Any ESC BEC should have handled it well.
Maybe there was steering binding or the servo EPA's (End Point Adjustments) were too great, thus allowing the servo to stall and overdrive the ESC BEC.

Who knows.

Danvers..... in MA??, if so:

1-Sorry about the teacher death there recently.
2-I have a customer site there (for the local electric utility).

Thanks Charlie for the reply! Danvers IL ..... end points adjusted,No binding that i was aware of. servo motor is locked up solid,does not seem to be gear related.